50/60HZ 0.75kw-160kw Solar Dc Pump Controller 3ph Solar Inverter

• Internal diagnostics will tolerate a lower input voltage

• Whenever possible, the controller attempts to regulate the pump load in a manner that optimizes for maximum power transfer from the solar array.
• The drive manually switches to AC backup power( when available) if the DC primary source is unable to support pump operation
• TI DSP technology and Infineon PIM design, high quality.
• MPPT function is available
• An easy to interface is provided to enhance configurability and enable remote system monitors
• A four-digit seven-segment display provides a detailed indication of systems status.
• Two line display keypad is options
• Built in RS485 ports through 7.5kw, laptop software control is available

Protection features

• Protection features : Electronic monitoring gives the controller the capability to monitor the system and automatically shut down in the even of: Dry run conditions- with smart pump monitoring, High voltage surge, Low input voltage, Open motor circuit, Short circuit, Over heat, Earth fault, Phase missing
• Dry protection : If no water in the ground, the water pump will stop working automaticallly and when the water comes, starts to working automatically.
• Automatic working: When the sunshine not good then pumps slow down automatically and when sunline become good then go on working.
• Save cost/directly connect solar panel: Solar panel connects solar inverter directly and to the pump. Also control the water level in the tank. No enough water in the tank working fast, enough water will stop working automatically. (how much water you need, you can set parameters)
• Speed & frequency control, No need battery: 0-320hz output by Vector control/0-3200hz output by VF control. No need battery in system.

Product Application





FAQ